Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
I CLEANING AND MAINTENANCE
·
To protect against electrical shock or burns, do not
immerse unit, cord, or plug in water or other liquid.
·
Failure to maintain this appliance in a clean condition
could adversely affect the life of the appliance and
possibly result in a hazardous situation.
I PRODUCT-SPECIFIC WARNINGS
·
Make sure that the cord is not damaged, twisted, bent,
or crushed. Do not pull on the cord or place anything
on top of it.
·
Never block the air inlet or air outlet.
·
Do not use or store the hairdryer in a humid
environment such as near a bath, shower, in a
bathroom, etc.
·
Nevertheless, if the appliance should fall into water,
immediately unplug it from the mains supply. Never put
your hands in the water.
·
The air outlet and attachments could become hot
during use. Do not touch them.
·
Make sure that the plug is fully plugged in before
switching on the appliance.
·
Do not drop the appliance. This may result in electric
shock or fire due to short circuit.
·
Do not use the hairdryer if the air intake is damaged.
Stop using it if you see fire in the air outlet. Clean the
·
appliance thoroughly and remove dust from the inlet
or outlet.
·
Always keep 10 cm between your hair and the air inlet.
Always keep 3 cm between your hair and the air outlet.
·
The hairdryer is protected from overheating. The power
supply is cut off if the appliance overheats. Switch
off the appliance and allow it to cool down for a few
minutes. Clean the appliance thoroughly and remove
dust from the inlet or outlet before switching it on
again.
·
The appliance could become hot during use. Persons
who cannot perceive heat should not use the appliance
or should only use it under supervision.
·
Wait for the appliance to cool down before storing it.
·
To avoid electric shock, do not insert any metal objects
through the air vents.
Do not use the appliance on artificial hair.
·
·
For extra safety, we advise you to install a residual
current device (RCD) in the electrical group supplying
the bathroom. This residual current-operated circuit
breaker must have a value that does not exceed 30 mA.
Consult the installer.
27
Publicité
Table des Matières
