EarthQuake 18493 Manuel Du Propriétaire page 14

Hold the hopper handle up so that the outer holes in the
handle align with the holes in the hopper and secure with
four M8 x 20 MM bolts (B), four M8 washers (E) and four M8
nuts (G). Insert the screws from the outside of the hopper.
FIGURE 7
TABS
Slide the tabs on the debris bag onto the support rod.
Secure the bag connector onto the chipper by rotating
the connector until locked in.
FIGURE 9
14 Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
HOPPER HANDLE
G
E
B
Slide the support rod into the bracket. Rotate the rod so
that it sits below the front tab of the bracket.
FIGURE 8
Owner's Manual
CHIPPER SHREDDER
BRACKET
SUPPORT ROD
TAB