Unpacking And Assembly - EarthQuake 18493 Manuel Du Propriétaire

UNPACKING AND ASSEMBLY

CARTON CONTENTS
TILLER ASSEMBLY
• Manual Parts Bag:
• Hardware Parts Bag:
• A - (4) M8 x 40 MM Bolts
• B - (4) M8 x 20 MM Bolts
• C - (3) M6 x 16 MM Bolts
• D - (2) 12 x 24 MM Washers
• E - (12) M8 Washers
• F - (3) M6 Spring Lock Washers
• G - (8) M8 Nuts
• H - (3) M8 Nyloc Nuts
• I - (3) M6 Nuts
• Cone Cover
• Debris Bag
• Safety Goggles
• (2) Wheels
• Hopper
• Bag Connector
• Bottle of 4-cycle Engine Oil
• Cone
• Chipper Assembly
• Handlebar
• Kickstand
• Hopper Guard
• Bag Support Rod
12 Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
KICKSTAND
Position the kickstand underneath the engine with the
loop of the kickstand pointing away from the wheel axle.
Using the four M8 x 40 MM bolts (A), eight M8 washers
(E) and four M8 nuts (G), secure the kickstand to the base
plate of the engine.
FIGURE 1
WHEEL AXLE
D
Slide the wheel so that the flange on the tire points out-
ward away from the unit, onto the axle and slide a 12 MM
washer (D) onto the axle against it. Insert the a cotter pin
into the hole in the end of the axle. Bend the cotter pin
over to secure the wheel to the axle. Repeat for opposite
side.
FIGURE 2
Owner's Manual
CHIPPER SHREDDER
G
WHEEL AXLE
E
A
COTTER PIN