Setting The Clock - Qlima SRE 3130 C Manuel D'utilisation

6
C

SETTING THE CLOCK

It is only possible to set the correct time, when the heater is connected to mains.
Press the
p
buttons to enter the actual time.
When the heater has been unplugged (or after a power failure), the time needs to
be set again.
D
IGNITING THE HEATER (Auto restart)
When used for the first time, a new heater may give out some fumes for a short while.
You therefore have to provide extra ventilation.
Always ignite the heater with the
A little white smoke and smell during ignition is normal. Just press the
to ignite the heater. The green power lamp inside the
indicating that the ignition procedure is running. This will take about 2 or 3 minutes.
Once the heater is really burning, the power lamp
will restart automatically after a power cut when the heater was in "on" position prior
to power cut. This makes it possible to switch the appliance on / off by interrupting /
enabling the power supply (for instance through a mobile phone switch).
E
QUICK IGNITION
Sometimes you may know in advance that you will be manually switching on the
heater within 12 hours, but you do not want to wait 2-3 minutes (see chapter D) at
that particular moment. For these occasions this heater is equipped with the "quick
ignition" function. This function will prepare the heater such that at the moment you
want to switch on the heater that upon pressing the
within 5 seconds. To start the "
In quick ignition mode:
The quick igition mode has to be enabled for at least 2-3 minutes before the heater
can be started.
F
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted when the heater is burning. Use the
buttons
minimum to +30°C maximum. The desired temperature is stored in the memory and
remains after a restart or power failure.
4
31
Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
key once and the word TIME will appear on the display. Use the
- the electrical power consumption is 100 Watt
- the air at the outlet is slightly warmed
- is automatically cancelled when timer function is set
- is automatically switched off after 12 hours
- can be cancelled by pressing the
light will now be off).
q p
and to adjust the temperature. The available temperature range is +6°C
button. Never use matches or a cigarette lighter.
will light continuously. This heater
button the heater will start
." function press the quick ignition button.
q
and
button
button will start to blink,
button again. (The