Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Connect green (or bare) ground wire from home power
supply to yellow-green ground wire in terminal box (D) using
UL listed wire connectors.
8.
Tighten strain relief screw.
9.
Install terminal box cover.
10.
Reconnect power.
Install duct covers
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with
two mounting screws.
NOTE: For vented installations, the upper vent cover may be
reversed to hide slots.
A
B
A. Upper vent cover
B. Lower vent cover
C. 4.2 x 8 mm screws
Complete Installation
1.
For non-vented (recirculating) installations only, install
charcoal filters over metal grease filter. See the "Range
Hood Care" section.
2.
Install metal filters. See the "Range Hood Care" section.
3.
Check the operation of the range hood blower and light.
See the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
All manuals and user guides at all-guides.com
C
D
C
D. Bracket
Range Hood Use
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the kitch-
en. The hood controls are located on the front side of the canopy.
C
D
A
A.Grease filter
B.Grease filter handle
C. Blower and light controls
D. LED lamps
Range Hood Controls
A
B
A. Timer button
B. Light button
C. Display
Timer Button
•
The default timer setting is 10 minutes, and it can be adjusted
between 20 minutes and 1 minute.
•
After pressing the timer key, the control enters to a timer se
up mode, and user can adjust the timer countdown time with
the "-" and "+" keys within 5 seconds. The timer can be
initiated immediately pressing the timer key, after setting the
timer duration or pressing the timer key twice (default 10
minutes setting).
•
If not action occurs within 5 seconds the countdown will start.
•
During the timer setup the "-" and "+" keys are dedicated to
the timer and no motor action will occur.
•
Once initiated the timer, it can be cancelled by pressing the
timer key again
Light Key
•
Press lamp key to turn ON the light (Lamp state previously
OFF).
•
Press lamp key to turn OFF the light (Lamp state previously
ON).
7
B
C
D
E
D. - button
E. + button
Publicité
Chapitres
Table des Matières
