Dismantling; Cleaning And Storage; Troubleshooting - MAXXMEE MG5001L-GS Mode D'emploi

EN

DISMANTLING

1. Rremove the storage bowl (1).
2. Undo the locking nut (11).
3. Remove the used insert with a screw-
driver or something similar and if
applicable the cutter head (15).
4. Take out the screw conveyor (16).
5. Remove the mincing attachment (2)
from the motor unit (3) by pressing
the release button (18) and turning
the mincing attachment to the right
and pulling it out at the same time.

CLEANING AND STORAGE

Please Note!
■
Do not use any caustic or abrasive
cleaning agents to clean the device.
These may damage the surface.
1. Dismantle the device in the reverse
order (see "Dismantling").
2. Remove any possible food residues
and clean all used parts (apart from
the motor unit!) with warm water and
detergent.
The perforated disc (11, 14), kebbe
inserts (9, 10), the sausage spout (8),
the shortbread attachment (6, 7) and
the pastry shape bar (5) can also be
cleaned in the dishwasher.
3. Then dry all parts thoroughly.
4. Wipe down the motor unit with a
damp cloth if necessary.
5. Store the motor unit and all accesso-
ries in a clean, dry place that is out of
the reach of children and animals.
6. The small accessories can be stored in
the accessories drawer (4).
20

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not work.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit of the mains plug.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the electrical dis-
tributor (fuse box).
The device switches itself off auto­
matically.
The device is overloaded.
►
Switch off the device and pull the
mains plug out of the plug socket.
Allow the device to cool down for
approx. 5 – 10 minutes. Then start
operating it again.
During use, an unpleasant smell is
detected.
The device is being used for the first
time. There are production residues
in / on the device. This is normal and will
not occur again later.
►
Make sure that the room is well
ventilated!