Load Parameter; Parameters Of The Safety Unit; Smcb-Display Parameters - Kübler SMCB Instructions D'utilisation

5.4. Load Parameter

5.4.1. Parameters of the Safety Unit

The „Load Data From..."- menu can be found as follows:
Safety Unit
After selection of „Safety Unit" in the first menu level, the parameter-sets to be
loaded are available.

5.4.2. SMCB-Display Parameters

The „Load Data From ..."menu is only for safety unit parameters available. The
parameters for the SMCB-Display unit are loaded directly after „Display Unit"
was selected in the first menu level.
Doc. # R60718

Load Data From ...
This menu option is only selectable, when data has
already been loaded from the safety unit or flash
memory.
To edit already loaded parameters, please select
„Use Loaded Data" and press OK to confirm.
To load actual parameters from the safety unit,
please select „Load Data From Safety Unit" and
press OK to confirm.
To load parameters for a safety unit from the
SMCB-Display flash memory, please select „Load
Data From Display Memory" and press OK to
confirm.
If „Load Data From Display Memory" is selected, but
no data has been saved in the flash memory, the
following hint appears:
„ATTENTION! No Data In Flash"
Electrical Connections
EN - 15