Methods Of Operation; Adjusting The Nailing Depth - Metabolic Devices NP 50A Manuel D'instructions Et De Sécurité

English

METHODS OF OPERATION

● After the lock lever has been pulled, nails
can be driven simply by pulling the trigger.
Do not touch the trigger or the lock lever
other than when driving nails.
● Do not drive one nail on top of another.
NOTE
When using the Nailer in low temperatures, operation
may be aff ected.
1. Set the lock knob to "Free" position
Turn the lock knob and align it with the "Free" position.
2. Using the trigger and lock lever
In addition to the usual trigger, this Nailer is equipped
with a lock lever that acts as a safety device. Nails are
driven by pulling the lock lever and then pulling the
trigger.
Lock lever
1
Trigger
3. Driving nails
1 Press the nail exit lightly against the position
where you want to drive the nail.
2 Pull the lock lever.
3 Pull the trigger.
1
3
14
WARNING
2
2

ADJUSTING THE NAILING DEPTH

● When adjusting the nose, be sure to lock the
trigger, remove your fi nger from the trigger
and lock lever, and disconnect the air hose
from the Nailer.
To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held fi rmly against the workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 Disconnect air hose from Nailer.
Screw
Nose
Screw
2 To adjust the driven-in depth of a nail, loosen the
screw that secures a nose.
If the nail is driven in deeply, adjust the nose to "up",
and if it's driven in shallowly, adjust the nose to
"down".
Too deep
Too shallow
WARNING
1 4
Disconnect air
hose