Maintenance And Care - Solo 115 Instructions D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

- Assembly of loop handle and personal safety bar

1. Turn the loop handle into the correct position.

2. Note: Always install the safety end-stop (1) on

the operator side of the motorised scythe. If, during

use, you carry the motor scythe on your r.h. side,

install the safety end-stop in l.h. orientation. How-

ever, if, during use, you carry the motor scythe on

your l.h. side, install the safety end-stop in r.h.

orientation.

3. Install the safety end-stop (1) on the loop handle

and secure with the spring clip (2).

To secure the loop handle, tighten screw (3)

with a screwdriver. We recommend the T-25

Torx key integrated into the Bypack. During

tightening, hold the opposite nut with an

open-ended spanner.

Assembly of Debris Shield

Remove pre-assembled parts (1-2). Leave all

other componentry in their pre-assembled

state. Insert square nuts into guard from the

top. Insert fastening screws (2) and tighten

evenly.

Note: Both front and rear lugs of the clamps

(3) must be placed in the locating holes on

both sides of the shaft tube.

Operation

Never operate without fitted contact

protection.

Preparation

- Adjusting the loop handle.

Adjust the loop handle for comfortable work

and body position (Abb. bzw. Fig.3)

-C onnect the trimmer to the outlet.

Check the outlet rating to see if it is

compatible with the unit identification data.

Use only approved outdoor extension cords

with the following minimum diameter rating.

Up to 75 ft/2,5 m long=1 mm

over 75 ft/2,5 m long=l.5mm

When using a cord reel, the cord must be

completely off the reel.

Plug the unit into the extension cord outlet and

secure with cord locking bar (Fig 5).

All manuals and user guides at all-guides.com

The trimmer has an anti-start guard to prevent

accidental starting.

Switching Unit On

• Assume Safe Stance

•Hold Wrap-around-handle with left hand

•Press locking pin on the left side (Fig.6, 1) of

the switch handle with the right thumb.

•Activate the trigger switch (2) with locking

pin depressed

•Release trigger lock.

Switching unit off: release the trigger switch

(the trigger lock resets into locking position).

Suggested Applications

Use the electric trimmer only to cut grass and

weeds. Typical applications are cleaning

•around walls and fences,

•around cracks, cobblestone walkways and

staircases,

•below bushes, trees and hedges.

overheating (for example, cut debris wrapped

around the string head can slow the motor

possibly causing overheating).

Under long and more severe operating condi-

tions, we recommend that occasionally the

motor is run for a few seconds at full speed

with no load to cool the motor.

The manufacturer's warranty excludes any

liability for damage to the motor that is

caused by overheating!