Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FIBER CONNECTOR SAFETY WARNINGS
SAFETY INFORMATION
1. Always wear safety glasses.
2. Isopropyl alcohol is flammable and may cause eye irritation. In case of contact with eyes,
flush with water for at least 15 minutes. When using isopropyl alcohol, always assure
proper levels of ventilation. In case of ingestion, consult a physician immediately.
3. Never look directly into a laser light source, point source at a person's eyes, or point
s ource at reflective surfaces.
4. When working on a fiber link, always turn laser source off, or disconnect completely.
5. Always dispose of fiber debris properly, preferably using sticky tabs.
6. Do not place food or beverages in the vicinity of the work area.
7. Thoroughly wash face and hands after terminating fiber.
8. Carefully remove any fiber debris that may have been stuck to clothing, or left in work
area, and dispose of properly.
TIPS AND RECOMMENDATIONS
1. Using isopropyl alcohol, thoroughly clean exposed fiber and buffer ensuring both are free
from dust, oil, and debris.
2. Do not lay ferrule dust covers on a dirty or dusty surface.
3. Always use proper tools and/or accessories to terminate fibers and clean connector tips.
TABLE OF CONTENTS
The following instructions will help you quickly install your Leviton Opt-X
use in your equipment cabinet or rack. For detailed information on each step, go to the page number listed below.
Safety and Installation Instructions
Table of Contents
Mounting, Front Door Operation, and Rear Door Operation
Front side patch cable routing, Opt-X
Page 2 of 30
Ultra High Density System Labeling
®
Ultra High Density System Enclosure for
®
Pg. 2
Pg. 2
Pg. 3
Pg. 3
Pg. 3
Pg. 4
Pg. 5
Pg. 6
Pg. 7
Pg. 8
Pg. 9
DI-000-5RXUD-20A
Publicité
Chapitres
Table des Matières
