LEGRAND Wattstopper HBEM3 Instructions D'installation

No: 24120 – 10/16 rev. 1
Catalog Number • Numéro de Catalogue • Número de Catálogo: HBEM3
Country of Origin: Made in China • Pays d'origine: Fabriqué en Chine • País de origen: Hecho en China
DESCRIPTION AND OPERATION
The HBEM3 Extender Module allows you to attach an HB350 series occupancy
sensor equipped with an HBNB3 back box to the side of a fixture. Once attached,
you can adjust the position of the sensor to be above, below, or to the front or back
of the fixture, up to 4.75" (120mm) from the fixture knockout.
Two chase nipples are included with the HBEM3. The short end of the chase nipples
snap into the HBNB3, or other plastic connection box whose walls do not exceed
2.4mm (0.09"). The long end of the longer chase nipple (1.24") fits into a metal
fixture with a standard knockout. If the fixture wall does not exceed 1mm (0.04") in
thickness, the nipple snaps into the knockout securely and the internal nut (included)
is not necessary. The included nut should always be used if the fixture wall is thicker
than 1mm (0.04").
The extender module snaps apart to allow threading the wires through it and into the
fixture for connection.
It snaps together to protect the wires.
Knockouts on the HBEM3 can be removed in various configurations to allow moving
the chase nipples and adjusting the height of the sensor on the fixture.
WARNING: TURN THE POWER OFF AT THE
CIRCUIT BREAKER BEFORE WIRING.
Determine the mounting location appropriate to the features of the power module
and the coverage area.
Careful consideration must be given to sensor placement. Avoid placing the sensor
where shelving or other obstructions may block the sensor's line of sight.
INSTALLATION
Wattstopper
High Bay Occupancy Sensor Mounting Bracket Extender Module
Module d'extension support de montage pour détecteur de
mouvement grande hauteur
Módulo de extensión para sensor de almacenamiento.
Installation Instructions • Instructions d'Installation • Instrucciones de Instalación
Maximum extension ..................................................4.75" (120mm)
Included .....................................................2 chase nipples and nuts
Inner diameter .....................................................0.63" (16mm)
Threaded outside diameter .................................0.82" (20mm)
Overall length:
........................................0.88" for connection to plastic fixture
......................................... 1.24" for connection to metal fixture
®
SPECIFICATIONS
Slide blade under tabs located
in 3 places. Gently pry apart.