Mounting The Camera - Dörr MD-5 Notice D'utilisation

03 | NOMENCLATURE
Camera screw with ¼" connection thread
1
2 Locking screw
3 ¼" female thread
⅜" female thread
4
5 Micro USB Port
6 LED indicator
7 On/Off button
8 Forward/Reverse
Speed up
9
10 Speed down
11 Front wheel
Curve angle scale
12
13 Rear wheel
Motor drive wheel
14
04 | CHARGING THE MOTOR DOLLY/LED INDICATOR
ATTENTION
Before first charging, unscrew the motor drive wheel (14) to remove the protective plate between battery and battery contact.
To charge the motor dolly plug the micro USB connector of the USB charging cable into the Micro USB port (5) and connect the motor dolly to your PC. While
charging, the LED indicator (6) lights up red. After the motor dolly is fully charged, the LED indicator (6) will turn off. If the remaining energy is low, the LED
indicator (6) flashes red.
05 |

MOUNTING THE CAMERA

Screw your camera onto the ¼" female thread (1) and tighten the locking screw (2) upwards.
06 | ADJUSTING THE CURVE ANGLE
To make the motor dolly move in a circle, set the front wheel (11) to the desired curve angle (12).
07 | TRACKING SHOTS
To start the tracking shot press the On/Off button (7). To move forward or backward press the button (8). For higher speed press the plus button (9). For
lower speed press the minus button (10).
CAUTION
Do not hold or rotate the motor drive wheel (14) manually during operation. This may cause damage to the motor.
•
Only operate the motor dolly on flat surfaces/undergrounds.
•
Take care that the motor dolly does not drop down while moving.
•
08 | CLEANING AND STORAGE
Never use aggressive cleansing agents or benzine to clean the device. We recommend a soft, slightly damp microfiber cloth to clean the outer parts of the
device. Make sure to take off the device from power before cleaning! Store the device in a dust-free, dry and cool place. This device is not a toy – keep it out
of reach of children. Keep away from pets.
3
11
12
1
2
5
6
7
8
9
10
14
07
3
4
13