Additional Functions; Troubleshooting Guide - Guardian Technologies SPA101 Instructions D'utilisation Et D'entretien

ADDITIONAL FUNCTIONS

1. Use the Power Button to turn the LED night light ON/OFF.
Press once: Diffuser ON/Night Light OFF
Press twice: Diffuser ON/Night Light ON
Press three times: Diffuser OFF/Night Light OFF
AFTER EACH USE
1. Turn the device OFF and unplug the unit from the electrical outlet. Lift off the top cover and the
inner water tank cover.
2. Drain and rinse the water tank thoroughly to remove any sediment and dirt. Wipe clean and dry
with a clean soft cloth or paper towel.
3. Remove water and clean the water tank after each use.
IMPORTANT: Do NOT fill with HOT water as this may cause leaking. Remove the water from the
tank when the diffuser is not in use.
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE DIFFUSER OR PERSONAL INJURY.
E-6
ON/OFF ALARM LIGHT

TROUBLESHOOTING GUIDE

PROBLEM SOLUTION
TIMER
Water vapor not produced. Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Air blows but water vapor is Excessive Water: Remove a certain amount of water from
not produced. the tank.
The diffuser mist has a bad smell. Poor maintenance or dirty water: Clean the product thoroughly, and
fill it with fresh water.
Unit has stopped working. No or low water. Unplug unit and refill tank.
Water is accumulating outside of unit Unit not level and water is accumulating. Unplug and place on
or area surrounding unit. level surface. Raise unit on a water-resistant level surface 2-3 feet
off of floor.
Increased noise level. Unit must be placed on a flat, level, hard surface. Make sure it is
NOT placed on a soft or absorbent surface.
Additional aromatherapy essential oils
can be purchased at www.guardiantechnologies.com
E-7