Duramaxx 10028499 Mode D'emploi page 41

Remote Control - Insert Batteries
Remove the cover from the battery compartment, by slid-
ing it in the direction of the arrow.
Insert the new batteries, ensuring that the (+) and (-)
directions are correct.
Refit the cover by sliding it into place.
Notes:
Use 2 LRO 3 AAA (1.5V) batteries. Do not use recharge-
able batteries. Replace the old batteries with new ones of
the same type when the display is no longer legible.
The remote control batteries must be disposed of in ac-
cordance with the applicable laws in force in the country
of use.
When you insert the batteries for the first time in the
remote control or if you change them, you will see a DIP
switch under the back cover (1).
DIP switch on Function
position
°C The display is adjusted in degree celsius
°F The remote control is adjusted in only cooling mode
Cool The remote control is adjusted in only heating mode
Heat The display is adjusted in degree Fahrenheit.
BE CAREFUL: After adjusting the function, you need to takeout the
batteris and repeat again the procedure described above.
Programming is very easy: as soon as you insert the bat-
teries, the symbols
flashing. If you push whatever button when the symbol
(COOL )is displayed, the remote control is adjusted
in only cooling mode . If you push whatever button when
the symbol (HEAT ) is displayed, the remote control
is adjusted in heating mode.
BE CAREFUL: if you adjust the remote control in cooling
mode, it will not be possible to activate the heating func-
tion in units with a heating pump. You need to take out
the batteries and repeat again the procedure described
above.
The remote control may be kept in a wall-mounted
holder.
(COOL ) and (HEAT ) start
41