Turbo Button; Operation Tips; Maintenance; Clean The Machine - Powerworks XB 40V Manuel D'opérateur

EN
If you decrease the speed all the way, the unit will stop
and it is necessary to do the first step again.

11.4 TURBO BUTTON

1. Push the turbo button (2), the machine is at the
highest speed.
2. Release the turbo button (2), the machine is at the
normal speed.

11.5 OPERATION TIPS

• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
•

Clean the machine.

• Discard the unwanted material when you complete
work.
12

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
NOTE
CAUTION
CAUTION
WARNING
English
12.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
13 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.

13.1 MOVE THE MACHINE

• Only hold the machine with the handgrip.

13.2 STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
14

TROUBLESHOOTING

PROBLEM
The motor does
not start when
you pull the trig-
ger.
8
CAUTION
WARNING
POSSIBLE SOLUTION
CAUSE
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.