Technical Data - Meec tools 019151 Mode D'emploi

Warning danger!
Wear ear protection
Wear safety glasses.
Use a face mask.
Safety class II
Electrical safety!

TECHNICAL DATA

Rated voltage
Output
Speed, no load
Sanding pad size
Sandpaper size
Sound pressure level, LpA
Sound power level, LwA
Vibration level
Weight
Cord length
Always wear ear protection!
The declared vibration value, which has been
measured by a standardised test method, can
be used to compare different tools with each
other and for a preliminary assessment of
exposure.
WARNING!
The actual vibration level when using power
tools may differ from the specified maximum
value, depending on how the tool is used.
It is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
230 V ~ 50 Hz
260 W
13,000 rpm
93 x 185 mm
93 x 230 mm
82 dB(A), K=3 dB
93 dB(A), K=3 dB
5.4 m/s², K=1.5 m/s²
1.7 kg
3 m
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
DESCRIPTION
Sheet sander with dust collector, clamp
and velcro fasteners for sandpaper, and
comfortable, rubber coated grips. Three
sandpapers (G60/80/120) included.
1. Lock button
2. Power switch
3. Dust container
4. End sandpaper clamp
5. Ventilation openings
6. Sandpaper clamp
7. Sanding pad
8. Front sandpaper clamp
9. Front handle
10. Ventilation openings
11. Main handle
FIG. 1
USE
FITTING SANDPAPER
1. Lift the sandpaper clamps (6) up and out.
The clamps are located on each side of
the Sheet sander. This releases the front
and end sandpaper clamps (4 and 8) on
the bottom part of the sander.
2. Put one end of the sandpaper with the
rough side up in the open front sandpaper
clamp (8) and check that it is in line
with the sanding pad. Lift the sandpaper
clamp up and in to clamp the sandpaper
in place.
3. Fold the sandpaper over the sanding pad
and insert it in the open end sandpaper
clamp (4).
EN
31