Operation - RIDGID WD16650 Manuel Du Propriétaire

Operation

!
WARNING: To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important signs
indicating abnormal operation such as loss of suction, debris/liquid exiting exhaust,
or abnormal motor noises. Immediately stop using Vac if you notice these signs.
• Do not leave Vac plugged-in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vac in areas with flammable gases, vapors or explosive dust in the air.
Sparks inside the motor can ignite airborne flammables. Flammable gases and
vapors include: lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol,
or aerosol sprays. Flammable dusts include: coal, magnesium, aluminum, grain, or
gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not use Vac as a sprayer.
!
WARNING: To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment. Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Do not service Vac while it is plugged-in. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into water,
return it to an independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition.
Do not allow the connection to come into contact with liquid.
• Do not vacuum toxic materials to reduce the risk of inhaling the vapors or dust.
To reduce the risk of electric shock, this
Vac has a polarized plug (one blade is
wider than the other). Except for 230 volt
models, this plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols.
= OFF
NOTE: When using the unit in the
vacuuming mode, always insert the air
diffuser in the exhaust port on the
detachable blower. This breaks up the
direct flow of air and diffuses it.
Familiarize yourself with the accessories
included with the Vac. Each accessory may
be used in various ways for vacuuming and
blowing debris. Here is a list of the
accessories and their uses.
= ON
9
Extension Wands - These wands can be
connected together and provides
additional length for more reach.
Utility Nozzle - General purpose nozzle for
most vacuuming applications.
Car Nozzle - Dry pickup nozzle for car
interiors and most upholstery cleaning.
Male To Male Adapter - Use this
accessory to connect the blower nozzle
to the exhaust of the power assembly
Wet Nozzle - Used for wet pickup on
smooth surfaces to pick up liquid and dry
the surface in one stroke.
Blower Nozzle - Attached to the end of a
hose or directly to the power assembly
concentrates the air for blowing
applications.
Diffuser - Insert in the exhaust of the Vac
while vacuuming and the air exiting the
exhaust is "diffused". This breaks up the
air coming out of the exhaust.
Hose - Provides transfer of vacuum or
blowing capability to work site. Provides
the means of attaching extension wands
and nozzles.
Accessory Caddy - Store all the
accessories with your Vac.
Caster Feet - Store accessories with
your Vac.