Gardeo GMTBT50HP55BS Mode D'emploi page 55

Wheels bracket release pedal
The spring-loaded wheels bracket release
pedal locks wheels bracket with depth
regulator rod at different height and distance
from the tines.
Press down on the wheels bracket release
pedal to release the wheels bracket. With the
tines touching the ground, an upward pressure
on the handles will fold the wheels bracket
toward the tines. With the wheels sitting on the
ground, a downward pressure on the handles
will unfold the wheels bracket away from the
tines. Release the pedal to lock the wheels
bracket in the desired position.
The unfolding and flexible wheels bracket with
depth regulator rod gives the tiller its versatility
and its stability. When the wheels bracket is
unfolded for tilling, the long length between the
tines and depth regulator rod provides more
confortable operation.
Depth regulator rod
Serves a dual purpose. It regulates the tilling
depth and helps the operator control the
direction and speed of the tiller.
Unfold the wheels bracket to raise the wheels
to one of the high positions. Set the depth
regulator rod with curve down to the rear of the
unit.
Lowering the depth regulator rod will slow the
tiller and make it till deeper. Raising the depth
regulator rod will allow it to move faster and till
more shallow.
Besides obtained from the wheels bracket
adjustment, the depth regulator rod can be
adjusted through its grooves.
To adjust the tilling depth.
1. Remove the cotter pin.
2.Raise or lower the depth regulator rod.
Align groove in depth regulator rod with the
holes in bracket lock block and replace the
cotter
pin.