Gardeo GMTBT50HP55BS Mode D'emploi page 52

Wheels bracket
1. Press down on the release pedal and insert
the lock block under the lock lever. Make sure
the spring-loaded lever locks in one of the
grooves.
2. Hook the wheel bracket on the tailpiece
bracket assembly.
3. Secure the wheel bracket lock block on the
wheel bracket with two M10X20 screws and
teethed washers.
Upper handle
1. Disassemble the handle adjustment knobs.
2. Mount the upper handle on the lower
handles with the handle adjustment knobs.
Throttle & clutch controls
1. Unwind the throttle control and clutch control
from around the engine. Straighten the cables.
Make sure that you do not bend or kink the
cables.
2. Remove the M6X60 carriage bolt and nut
from the throttle control assembly. Mount the
throttle control on the left side of the upper
handle with the hardware removed. Make sure
the throttle control is mounted outside the
handle.
3. Remove the M6X40 socket screw and nut
from the clutch control lever assembly. Mount
the clutch control lever on the right side of the
upper handle with the hardware removed.
Make sure the clutch control lever is mounted
on the top of the handle.