Power Dynamics PD504 Serie Manuel D'instructions page 5

OPERATION
• Switch on the receiver with the power switch.
Screw or open the battery cover of microphone and put
•
new or full charged battery inside. Press the power
switch on the microphone for 2 seconds, to switch on.
Select your transmission channel, with the ▲ and ▼
button on the receiver. Hold the IR sensor of microphone
close to the IR sensor of the receiver. Press shortly on
the SET button of the respective channel to synchronize
the microphone.
When the receiver and the microphone have been set to
•
the same transmission channel, the RF bargraph on the
receiver's display will indicate that a radio signal is being
received.
Noted: how more numbers of bars are displayed, how
better is the reception.
Screw or close the battery cover onto the microphone again.
•
For optimum receiving:
Reposition the receiver so there is nothing obstructing a line of sight to the microphones (including the audience).
•
• Avoid placing microphone and receiver where metal or other dense materials may be present.
Place the receiver on the top of the equipment rack.
•
Remove nearby sources of wireless interference, such as cell phones, two-way radios, computers, media players, Wi-
•
Fi devices, and digital signal processors.
• Charge or replace the microphone battery.
• Keep microphones more than two meters (6 feet) from each other.
Keep the microphones and receiver more than 5 meters (16 feet) apart.
•
During sound check, mark trouble spots and ask presenters or performers to avoid those area.
•
HEADSET MICROPHONE
Connect the connecter of supplied headset microphone to the
connecting jack of bodypack.
Position the headset microphone approx. 15 mm (1/2 inch) from
the opening of your mouth.