Hyundai Reboarder 360 Mode D'emploi page 21

Removing the belt systems
•
Loosen the belt.
•
Unlock the harness and shoulder pads on the back
and then remove the belt system.
Installation with Isofix
•
Push the yellow insertion aids through the slot in
the upholstery between backrest and seat and into
the Isofix brackets.
•
Make sure the flat side is facing down. This is not
necessary if the vehicle already has fixed insertion
aids.
•
Press both side Isofix connector buttons to extend
the Isofix connectors in length.
•
Insert the Isofix connectors into the insertion aids
and press until you hear them click into place.
•
The display on both sides only turns green when
the connections are made. Press the child car seat
against the backrest until it is secure.
Installation with Top-Tether
•
Take the top tether out of the pocket.
•
To release the top tether, press the grey adjustment
button with one hand and pull the side of the belt
anchor to the required length with the other hand.
•
To attach the Top-Tether, attach the anchor to
the attachment point on the car seat and pull it
as tightly as possible. The indicator does not turn
green until the belt is locked.
- 21 -
EN