Miele Blizzard CX1 Electro Instructions D'utilisation page 14

en
For further information on use and
maintenance please refer to the sepa-
rate instructions supplied with the Elec-
trobrush.
Connecting the telescopic wand to
the floorhead/floorbrush (Fig. 06)
(included as standard depending on
model)
 Push the telescopic wand into the
suction nozzle and turn it clockwise
or counter-clockwise until it clicks
into position.
 To detach these parts from each
other, press the release button and
pull the telescopic wand out of the
suction nozzle, twisting it slightly as
you do so.
Using the reversible floorhead
(Fig. 07)
(included as standard depending on
model)
Please be sure to observe the floor-
ing manufacturer's cleaning and care
instructions.
The floorhead can be used for vacuum-
cleaning carpets and rugs. It is espe-
cially suitable for cleaning hard flooring
which is not susceptible to scratching.
Adjusting the floorhead (Fig. 07)
Vacuum carpets and rugs with the
brush retracted:
 Press the foot switch .
Clean hard flooring which is not sus-
ceptible to scratching, as well as floor-
ing with gaps or deep crevices in it with
the brush protruding:
14
 Press the foot switch .
Using the accessories supplied
(Fig. 08)
 Crevice nozzle
For cleaning in folds, crevices or
corners.
 Upholstery nozzle
For cleaning upholstery, mat-
tresses, cushions, curtains, cov-
ers, etc.
 Dusting brush with natural bris-
tles,
included in loose form
For cleaning base boards as well
as ornate, carved and particularly
sensitive objects. The head can be
swiveled to adjust to the best an-
gle.
The crevice nozzle and the upholstery
nozzle are located in holders at the rear
of the vacuum cleaner.
Floor brush (Fig. 09)
(included as standard depending on
model)
For general use and also for vacuuming
the stairs.

For safety reasons when vacu-
uming stairs, it is best to start at the
bottom of the stairs and move up-
wards.
Floorbrush Parquet Twister with
swiveling head (SBB 300-3)
(included as standard depending on
model)