Mounting Oven To The Wall; Preparation Of Top Cabinet - Viking VMOH330SS Guide D'installation

• Position mounting plate on wall and insert toggle bolt
assemblies through the drywall holes or start the lag
screw(s) through the wall stud(s). See Figure 20.
• Next, secure mounting plate to the wall by tightening
toggle bolt assemblies or lag screw(s). See Figure 21.
3
• Drill / " diameter lag screw hole(s), into one or more
16
wall studs.
(Remember, you must have at least one lag screw
secured to a wall stud.) For stud location refer to WALL
CONSTRUCTION, see page 3.
• Tighten the lag screw(s) into wall stud(s).

MOUNTING OVEN TO THE WALL

NOTE: IT IS VERY IMPORTANT THAT THIS OVEN BE
INSTALLED BY TWO PEOPLE.
IMPORTANT: DO NOT GRIP OR USE HANDLE DURING
INSTALLATION.

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the template.
NOTE: TOP CABINET TEMPLATE instruction must be
installed to proceed.
STEP 1
• Protect the top of your range by placing a portion of the
carton or some other heavy material over the cooking
surface before mounting your oven.
1.TINSKB278MRR0_Viking_VMOH330SS_OTR_Install_E,S,F.indd 8
Space more than
wall thickness
Dry Wall
Figure 20
Figure 21
STEP 2
• Lift the microwave oven and tilt it forward.
• Hang the unit on two tabs at the bottom of the mounting
plate. See Figure 22.
Figure 22
STEP 3
• Thread power cord through the hole at the bottom of
the top cabinet.
• Swing the unit upward to meet the top of the mounting
plate and hold it securely. See Figure 23.
Figure 23
E 8
1/31/19 11:07 AM