Publicité
Section 4
Removing Cover
Step 1
Step 1
To remove cover: Use the loops at the Right or
Left rear corner and ease the plastic strip out of
the rail by pulling DOWN and OUT. Then peel the
plastic strip out of the remainder of the rear rail. Pull
DOWN and OUT on the vinyl fabric to remove the
plastic strips from the sides of the rail assembly.
Roll cover toward cab of truck. Use Hook & Loop
straps attached to front of rail to secure cover.
To fasten cover, repeat installation step 3.
The rear rail can be used to help roll the
cover up.
P7 - 18240 - Rev. A 1114
Peel Plastic
Strip out of
Rear Rail
Installation Instructions - ZipRail Tonneau
Pull Down and
Out on Loops
Page 7
© 2014 Bestop, Inc.
Publicité
