Publicité
Section 3
Secure Fabric
Step 1
Make sure Front Strip
is centered side to side
before continuing
Step 1
Make sure the inside edge of the Front Rail is
aligned with the inside edge of the bed and that the
Rail Assembly is centered from side to side on the
vehicle.
Check that the front strip on the Tonneau Fabric is
centered in the Front Rail. If not slide the strip in the
rail until it is centered.
The plastic strips along the three sides of the vinyl
cover fit into the grooves in the rail assembly.
P6 - 18240- Rev. A 1114
Secure Sides starting
at either front or rear
Installation Instructions - ZipRail Tonneau
Loops should
remain exposed
Fabric Tag on
Cover should be
centered over
Tailgate Latch
Start in center
and work out
to corners
Page 6
Cover
Plastic
Strip
Roll the cover out toward the rear of the
vehicle. Make sure the bows fall between the
side rails. Adjust the clamps if needed. Cen-
ter the fabric tag above the tailgate latch and
begin inserting the rear plastic strip into the
groove working from the center out to each
rear corner. Use one hand to insert and the
other to guide the plastic into the groove.
Start at either the front or rear corner to
insert the side plastic strip into the groove.
Work to the opposite corner. Repeat on both
sides.
© 2014 Bestop, Inc.
Publicité
