Mono Sub With Passive Satellites Using Line Inputs - Samson Audio RESOLV 120a Manuel Du Propriétaire

Connecting the RESOLV 120a

Mono Sub With Passive Satellites Using Line Inputs

The RESOLV 120a can be operated using line level inputs and outputs. When using the RESOLV 120a at line level, the full
range signal is maintained at the outputs. Below is a typical system set-up using the RESOLV 120a with a mixer, stereo
power amp and a pair of passive satellite loudspeakers. The RESOLV 120a's inputs and outputs utilize industry standard
RCA connectors. For a detailed wiring diagram, see the section "RESOLV 120a Connections" on page 17. Follow the steps
in the diagram below to set up your system.
– +
INPUT
PUSH TO RESET
20A / 250V
~
AC INPUT
115V / 60Hz, 800W
���� �����
• Lower your mixer's master outputs to all the way off.
• Connect the mixer's left output to the RESOLV 120a's LEFT PREAMP LEVEL INPUT and the mixer's right output to the
RESOLV 120a's RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120a's LEFT PREAMP LEVEL OUTPUT to the
left side input of the power amp, and the RESOLV 120a's RIGHT PREAMP LEVEL OUTPUT to the right side input of the
power amp. Connect a speaker wire from the left output of your power amp to your left satellite, and then, connect a
speaker wire from the right output of your power amp to your right satellite.
• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner's manual for a recom-
mended crossover point. You can also use your ears by adjusting the SWEEP control to the frequency that sounds
good to you. A good place to start is about 70 Hz.
• Now set the level of your power amp up to the normal operating level. Run an audio signal (like some music from a
CD) through your mixer and raise the level to a comfortable listening level. Now slowly raise the RESOLV 120a vol-
ume control and listen to the low frequency output. Adjust the RESOLV 120a to the level of low frequency output
that you like. Now, when you raise and lower your mixer's output, the RESOLV 120a and satellites will track at the
same relative volume.
���������
OUTPUT
CHANNEL 2
MINIMUM LOAD IMPEDANCE
- +
STEREO
(4/CHANNEL)
BRIDGED MONO
-
(8)
SERIAL NUMBER
�����
���� � ���� ����
������
���� � ������ �� ���� ���������� �� ��� ������
�� ��� ������ ���� ��������� �� ���� �� ���������
�������
���� �� �������� �����
�� ��� �����
MADE IN KOREA
14
������
�������
�� ������� ������ �� ��� ����� �� ���� ����������� ����� ������� ����� ��������� ��
��������� ������� ���������� �� ������� ���� �� ����� ������� �� ��� ������ ��
���� �� ���������
CHANNEL 1
CAUTION
; REPLACE WITH THE SAME TYPE FUSE AS INDICATED.
UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.
INPUTS
TIP RING SLEEVE TIP RING SLEEVE
TIP + TIP +
RING - RING -
+ -
CHANNEL 2 CHANNEL 1
SLEEVE GND SLEEVE GND
+
MODE SELECTOR
INPUT INPUT
BRIDGED STEREO
(10K / 0dBu) (10K / 0dBu)
www.samsontech.com
– +
INPUT
�� ���� ���� ����� ���������� ��� ���� ���������