Drive Medical RTL11148KDR Mode D'emploi page 3

4. Attach the front of the pail support frame into the
side frame as shown in (figure 5). Be sure the push
pins appear through the side frame hole. Repeat
on the other side.
Pail Support
Side
Frame
Bottom
figure 6
Important Note: Be sure the pail support frame is on
the underside of the cross brace (figure 6).
5. Attach the backrest by depressing both push
pins and sliding the back support into the frame
receptacle (figure 7).
figure 7
Rev.4.04.28.14
Frame
figure 5
Backrest
6. Lower commode bucket into frame and attach seat
and lid onto the back of the frame (figure 8).
Item # RTL11148KDR
figure 8
adjusting leg height
1. Before use, adjust height of each leg to
your specific needs, making sure all legs
are at the same height. When desired
height is reached, lock legs into place by
aligning buttons into proper holes, per
illustration to the right.
2. Be sure legs are locked into place by
pushing down on or by pulling legs.