Settings Menu; Adjusting Grinding; Using The Scales - Fiorenzato XGR Manuel D'instructions

light up . U se the buttons C1 and C2 to move
through the menu and change the setting .
Use the button M to select and confirm . Exit
the menu after confirming by pressing the
button M .
• Language: English, Italiano, Español,
Français, Deutsch, Português, Chinese,
Russian, Korean, Malaysian, Thai, Greek .
• Time: set time .
• Time Layout: 12 or 24 hours .
• Date: set date .
• Temperature: Centigrade or Fahrenheit .
• Brightness: adjustment in percentages .
• Information: Firmware version and Serial
Number .

SETTINGS MENU

To access the SETTINGS menu, keep the but-
ton C1 pressed until an intermittent sound
starts (about 5 secs .) . Three yellow buttons
will light up . U se the buttons C1 and C2 to
move through the menu and change the set-
ting . Use the button M to select and confirm .
Exit the menu after confirming by pressing
the button M .
• GRINDING WEIGHTS: single and double
dose weight adjustment .
• CALIBRATION: dose setting .
• SCALES: free weight system .
• GRINDING BLADE REPLACEMENT: hours .
• GRINDING BLADE RESET: reset mills timer .
• FACTORY RESET: restore factory settings .
• STATISTICS: show statistics .
• MANUAL GRINDING: activate manual
grinding button M .
• GRINDING MODE: Standard, Automatic,
PRE/SEL e Direct .
When the grinding blades need to be re-
placed, a warning appears on the display . The
state of wear can be monitored by accessing
the SETTINGS menu and selecting GRINDING
BLADE REPLACEMENT .
After replacing the grinding blades, the re-
placement timer needs to be reset . To do this,
access the SETTINGS menu, select GRINDING
BLADE RESET and confirm the reset .

ADJUSTING GRINDING

In order to achieve finer or coarser grind-
ing and therefore vary the granulometry,
use the adjustment disk located under the
hopper .
To increase the coarseness of the ground
coffee, the adjustment disk must be rotated
clockwise, pressing the adjustment disk lock
downwards, to decrease turn the disk anti-
clockwise . When the coffee grinder is
switched on, as indicated in the paragraphs
WARNINGS FOR INSTALLATION AND ELEC-
TRICAL CONNECTION and OPERATING THE
GRINDER-DOSER,adjustment can be carried
out by pressing the button M (hand) on the
display, which starts the grinding, possibly
without coffee between the grinding blades .
It is advisable to grind small amounts of cof-
fee to facilitate a visual check of optimum
granulometry and, if required, adjust the
grinding adjustment disk . If the coffee comes
out of the espresso coffee machine very
quickly, it means that the coffee is ground
too coarse . Vice versa, if it comes out too
slowly, it means the coffee is ground too
fine . Nonetheless, bear in mind that there
are many conditions liable to influence the
correct supply, such as the weight of the
portions, the compacting, the espresso ma-
chine settings and the cleaning of the filters .

USING THE SCALES

After removing the coffee collection tray,
place the coffee collection container provid-
ed in its housing on the calibration plate, so
that the two parts correctly match up (see
Fig .2) .
25 25