Powering On A Gv Convergent Controller; Configuring Gv Convergent - Belden grass valley GV CONVERGENT Mode D'emploi

Step 3: Powering on a GV Convergent Controller
To power on a GV Convergent Controller for the first time:
1 Remove the bezel, following the directions in the SuperMicro, SuperServer© Manual.
2 Press the Power button.
Step 4: Configuring GV Convergent
To configure the GV Convergent Controller Network Settings
1 In a web browser, enter the Management IP address of the GV Convergent controller.
The default is
The GV Convergent login screen appears.
Note: Ensure that the PC or laptop, you are using to connect to
GV Convergent, is within the same subnet as the management Ethernet
port (em1) on GV Convergent.
.
10.0.3.10
GV Convergent Quick Start Guide
1. Unlock
2. Press release knob
3. Remove bezel assembly
Power button
3