Galvamet MASAI Instructions Pour L'installation, L'utilisation Et La Maintenance page 8

MAINTENANCE
Always disconnect the hood from the mains before carrying out any maintenance or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that are designed to trap particles of fat contained in the fumes. The metallic anti-
grease filters must be washed at least once a month or, if present in this model, when indicated by the electronic notice, with detergent in hot water (or
in the dish-washer).
To remove the metal grease filters, press and release as shown in Fig. 12 B.
To wash the internal filtering parts of the aluminum net in the dishwasher, it is necessary to disassemble it from its structure as indicated in Fig. 12 C
and Fig. 12 D.
Do not wash the outer frame (Fig. 12 B) and the internal structure (Fig. 12 C) that contain the metal filters in the dishwasher.
It is advisable to refit the grease filters only once they are dry.
ATTENTION: the grease collected in the filters can easily catch fire and it is therefore extremely important to clean the metallic filters on a regular basis
as per instructions.
The Plasma anti-odor filter does not require any particular maintenance and its duration is about 10 years while maintaining its efficiency in eliminating
the virus odors bacteria in the air.
The hood features a LED light that, in addition to offering a good lighting and a significant energy savings, are guaranteed to last on average 10 times
more than traditional lights. For replacement, contact the Assistance Service.
In order to remove the remaining glue or any impurity, the cooker hood must be cleaned immediately after installation and after having removed the
protective film.
The cooker hood must be cleaned frequently both internally and externally (at least once a month).
Do not let dirt gather on the inner and outer surfaces of the hood.
To clean the exterior of the hood do not use either acid or basic products, or abrasive sponges.
Clean the hood with a sponge dampen in warm water and a little quantity of neutral detergent (for example dishwasher detergent), in order to remove
possible particles of grease.
Rinse with a damp cloth, removing all the detergent carefully, following the satin finish direction on the steel surface.
Drying is very important, especially in areas where water is particularly hard and leaves limestone.
All the ordinary and extraordinary maintenance can be performed without having to remove the hood.
8