Table des Matières
Publicité
TABLEAU DE REPASSAGE
REMARQUE: Avant de commencer le
repassage de tissus délicats, il est bon
de vérifier la température de l'appareil
en repassant un bord ou une couture
intérieure.
DIRECTIVES
SUR
L'ÉTIQUETTE
FIBRES
SYNTHÉ-
TISSU
TIQUES, p. ex.
acrylique,
nylon,
polyester
MIN
RÉGLAGE
DE TEMP.
•
BOUFFÉE
DE
VAPEUR
Réglez la
température à
« MAX »
Pour choisir la température de
l'appareil, alignez la température
choisie sur le cadran avec
l'indicateur sur le réservoir d'eau.
SOIE
COTON
LAINE
LIN
MAX
• • • • •
18
BEFORE FIRST USE
Remove any labels, stickers or tags which may be attached to the body or soleplate of
the garment steamer/iron before using the appliance.
Read all instructions for use carefully. Always follow the Important Safeguards
IMPORTANT
The first time an iron is used, some odor and small white particles may come out of the
steam vents. This perfectly normal and will cease to occur after the iron has been in
use for a short while.
Before you start using your garment steamer/iron, follow the instructions in the manual
and do the following in order to eliminate any odor and small white residue particles and
to ensure optimum steam performance.
• Fill the garment steamer/iron with regular tap water.
• Set the temperature control dial to its highest setting.
• The pilot light will go off to indicate that the garment steamer/iron has reached the
selected temperature.
• Keep the iron in a horizontal position and allow it to steam until the water runs out.
• Press the steam trigger to eliminate white residue particles.
• Repeat this procedure through 2 or 3 fillings.
OPERATING INSTRUCTIONS
Before using your iron, check the
voltage and type of plug that is
required for your location. If
necessary, readjust the dual voltage
switch according to local voltage –
115V, 60 Hz., 230V, 50 Hz. This is
accomplished by sliding the dual
voltage control switch located in the
rear of the iron to the corresponding
voltage setting.
Note: The voltage selector is preset
at the factory for use on 115V, 60 Hz.
N. A. household current.
Caution:
Always disconnect the iron before adjusting the dual voltage
switch to the correct voltage setting.
.
3
Publicité
Table des Matières
