Table des Matières
Publicité
FAMILIARISEZ-VOUS AVEC VOTRE
VAPORISATEUR DE VAPEUR POUR VÊTEMENTS/FER
Spécifications Techniques
Tension :
115/230 V., 60/50Hz.
Puissance :
800 watts
1. Cadran de commande de
la température
2. Voyant rouge
3. Bouton de vapeur
4. Couvercle de l'orifice
d'entrée d'eau
5. Brosse rouge à peluches
6. Brosse à soies pour
vêtements
7. Languette de verrouillage
8. Poignée pivotante
9. Godet à mesurer l'eau
10. Sélecteur de tension
double (non illustré)
12
TROUBLESHOOTING
PROBLEM
POSSIBLE REASONS & SOLUTIONS
• Make sure that the plug is securely in the socket.
Garment
• Temperature setting too low.
Steamer/Iron does
Turn to higher setting.
not heat
• This is normal.
Pilot light
The light goes On and Off as the thermostat is
goes On and Off
switching the heating element On and Off to
maintain the selected temperature.
Some odor or small
• This is normal.
particles come out
Follow instructions for first use and allow iron to steam
of steam vents of
through 2-3 fillings & press the steam trigger
new iron
occasionally to eliminate small white particles.
Garment
• Water tank may be empty or water level is very low.
Steamer/Iron does
Add water.
not steam
• Make sure that the temperature control dial is correctly
set. For maximum steam, (setting 'Max' on steam
control), temperature control dial should be set on '•••'.
• Make sure the iron has reached the selected
temperature by confirming that the pilot light has gone
"Off". For more steam, turn temperature dial to
higher setting, e.g. '•••'.
• If temperature setting is correct and there is no steam,
gently tap the soleplate on the ironing board a few
times. Move the temperature control dial from 'MIN' to
'Max' a few times.
• Iron may not be hot enough. Set temperature control
Water droplets coming
dial to the 'Max' position. Always allow iron sufficient
from steam vents
time to heat up (pilot light goes off).
• Overuse of steam trigger. Allow more time between
each burst.
• Iron may have been overfilled. Turn iron off,empty
water and follow instructions for filling.
• Steam performance may be low if iron requires
seasoning. To season, use regular tap water for 1or 2
tanks until steam performance improves.
9
Publicité
Table des Matières
