Brizo MultiChoice VETTIS T60P088 Guide D'utilisation page 3

Cartridge Installation
1
A.
2
1
Turn off water supplies. Remove cover
(1), bonnet nut (2), test cap (3) and
plasterguard (4). If screen (5) is in place,
remove before installing cartridge.
Back to back Installation
Normal Installation (changes not required)
Reverse
Installation
Cold
For back to back or reverse installations
(hot on right and cold on left) insert the
cartridge with the "hot side" on the right.
If you are not making a reverse or back
to back installation skip this step and
continue with step 1C.
4
5
3
Hot
T60P Series Installation
B.
2
4
1
Rotate the cartridge (1) so the words
"hot side" (2) appear on the left. Insert
cartridge into valve body as shown. Make
sure the cartridge tubes and O-rings (3) are
properly seated in holes at the base of the
body. Ensure the keys on the body are fully
engaged with the slots in the body (4).
C.
Slide bonnet nut (1) over the cartridge
and thread onto the body. Hand tighten
securely.
3
3
1
91836 Rev. A
4