Remote Control - Dimplex Revillusion RLG25BR Manuel D'utilisation

Operation

Remote Control

The fireplace is supplied with a multi-
function remote control.
The remote control has a range of
approximately 30ft (9m). To operate
correctly, the remote control must be
pointed toward the front of the unit.
Power
Press to turn the flame effect on
and activate the previous heat
setting (Off, Low, or High). Press
again to put the unit in standby
mode.
Flame
Press to light the back log and
ember mat, and start the flame
effect.
10
Heat
• Heat On
Press to set the heat to Low
(indicated by 1 short beep).
Press again to set the heat
to High (indicated by 2 short
beeps).
• Heat Off
Press to turn heat Off (indicated
by 1 long beep).
!
NOTE: After the heater is
switched off, the fan will continue
on for 60 seconds before turning
off.
!
NOTE: Heater will only turn on
when the flame effect is on.
360 Light
o
Press multiple times to change
the LEDs on the sides and back
of the unit from white flickering to
white solid to Off. (This feature is
active only when the flame effect
is On.)
Brightness
Press multiple times to toggle
the log set LEDs through its four
brightness settings.
www.dimplex.com