Hedge Trimmer - Meec tools 900 W Mode D'emploi

Always wear ear protection.
The declared vibration value, which has been
measured by a standardised test method, can be
used to compare different tools with each other
and for a preliminary assessment of exposure.
WARNING!
The actual vibration level when using power
tools may differ from the specified maximum
value, depending on how the tool is used. It is
therefore necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling, in
addition to the start-up time).
DESCRIPTION
1. Starter cord
2. Throttle control
3. Fastener for harness
4.

Hedge trimmer

5. Harness
6. Shaft coupling
7. Trimmer spool
8. Clearing blade
9. Shaft
10. Chain saw
11. Front handle
12. Power switch
13. Start inhibitor
14. Guard
15. Container for saw chain oil
FIG. 1
Chain saw
1. Sprocket cover
2. Saw bar
3. Saw chain
4. Oil filler
5. Shaft
FIG. 2
Hedge trimmer
1. Shaft
2. Adjustable handle
3. Blades
4. Adjustment lever
FIG. 3
ASSEMBLY
BRUSH CUTTER/TRIMMER
Fitting the front handle
1. Release the hex screws.
2. Place the bottom of the handle on the
shaft.
FIG. 4
3. Fit the top part of the handle on the
bottom part.
4. Firmly tighten the screws.
FIG. 5
Fitting the guard
Fit the guard on the shaft. Make sure to tighten
the screws properly.
FIG. 6
WARNING!
Only use parts and accessories recommended
by the manufacturer. The use of other parts
can result in personal injury and/or material
EN
75