Samsung 6 Serie Guide De L'utilisateur page 31

9. When done, press the Blue button on your remote. The
Network Connecting screen appears.
10. Wait until the connection confirmation message is
displayed, and then press the ENTERE button. The
Network Setup screen re-appears.
11. To test the connection, press the
select Network Test, and then press the ENTERE
button.
Network Setup (Ad-Hoc)
You can connect to a mobile device without an access point
through the "Samsung Wireless LAN Adapter" by using a
peer to peer network.
✎
This function is available when
SWL(Samsung Wireless Link) is set to Off in the TV's
on-screen menu.
How to connect to new Ad-hoc device
1. Follow Steps 1 through 6 in the "How to set up using
PBC (WPS)" (p. 30).
2. Choose Select a Network. A list of devices/networks
appears.
3. While in the device list, press the Blue button on the
remote.
✎
The message Ad-hoc is a direct Wi-Fi
connection with cell phone or PC. The existing
network system may have limited functionality.
Do you want to change the network
connection? is displayed.
4. Input the generated Network Name (SSID) and
Security Key into the device you want to connect.
How to connect an existing Ad-hoc device
1. Follow Steps 1 through 6 in the "How to set up using
PBC (WPS)" (p. 30).
2. Choose Select a Network. The Device/Network list
appears.
3. Select the device you want in the Device list.
4. If security key is required, input the security key.
✎
If network doesn't operate normally, check
the Network Name (SSID) and Security Key
again. An incorrect Security Key may cause a
malfunction.
Network Setup (Manual)
If the other methods do not work, you need to enter the
Network setting values manually.
Getting the Network Connection Values
button to
RETURN
To get the Network connection values on most Windows
computers, follow these steps:
1. Right click the Network icon on the bottom right of the
2. In the pop-up menu, click Status.
3. On the dialog that appears, click the Support tab.
4. On the Support tab, click the Details button. The
How to set up manually
To enter the Network connection values manually, follow
these steps:
1. Follow Steps 1 through 6 in the "How to set up using
2. Press the ▼ button to select Internet Protocol Setup,
3. Press the ▼ button to go to the first entry field (IP
4. Use the number buttons to enter numbers.
5. When done with each field, use the ► button to move
6. Enter the IP Address, Subnet Mask, and Gateway
7. Press the ▲ or ▼ button to go to DNS.
8. Press the ▼ button to go to the first DNS entry field.
9. When done, press the ▲ button to go to Select a
10. Go to Step 4 in the "How to set up automatically"
screen.
Network settings are displayed.
PBC (WPS)" (p. 30).
and then press the ENTERE button. Press the ▲
or ▼ button to select Manual, and then press the
ENTERE button.
Address).
successively to the next field. You can also use the other
arrow buttons to move up, down, and back.
values.
Enter the numbers as above.
Network. Select your network, and then press the
ENTERE button.
(p. 30), and follow the directions from that point on.
31
English