VOLTCRAFT LSG-3 Mode D'emploi page 37

Proceed as follows for the cable test:
• Slide the switch (14) on the side to the
"TEL" position for signal the telephone
cable test.
• Connect the net probe through the
built-in RJ45 jack (4) t4o an optional
RJ11/RJ45 connecting cable and a tele-
phone socket or
• Connect the two telephone cables to
the test connections (6) on the back, La
to - / Lb to +.
• The test button (9) may not be pressed.
• The status displays have the following significance:
The green LED flashes.
voltage exists, polarity is correct.
The green and yellow LED flashes.
Alternating voltage is pending.
The yellow LED flashes.
The polarity is incorrect
The green and yellow LED flashes.
Bell voltage is pending.
36