Motor Protection; Installing The Saw Blade; Various Sawing Processes; One-Step Sawing - Rodia 4050TS Manuel D'utilisation

RODIA
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm 2

Motor protection

The motor is equipped with a thermal
safety switch for protection against an
overload. When the motor gets over-
heated, the switch falls back into its initial
position and can only be switched on
again after the motor is cooled down. The
switch also protects against power failure.
When the power returns, the motor will not
start on its own but must be switched on
by hand.

Installing the saw blade

WARNING!
Make sure to disconnect the
machine from the power supply
before fitting or switching the
saw blade or when doing any
maintenance
on the
machine.
• Remove saw
cover.
• Block the sawing
spindle with the
4050TS-4060TS
®
.
6 mm Allen wrench.
• Unscrew the hexagon nut with the
wrench and remove the saw flange.
• Clean the saw flanges.
• Fit the saw blade on the centre ring of
the motor flange. (Check the direction
of rotation and make sure the blade is
well centered.)
• Mount saw flange and tighten with
the hexagon nut. Place saw cover and
tighten with the 2 knobs.
7. VARIOUS SAWING
PROCESSES

One-step sawing

(Use only original saw blades as advised
by the manufacturer)
• Move saw head down until the saw is
approximately 10 mm below the saw
table.
• Secure saw head with the knob.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
• Hold the material with two hands while
making sure your hands are free from
the sawing blade.
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial.
19
GB