CLAS OH 0336NBL Mode D'emploi page 15

OH 0336NBL 1T FOLDABLE CRANE
Lock Washer
Nut
Washer
Figure I.
Bolt
Use a bottom ram bolt, washer and nut to attach lower
(#33)
end of the ram to the post and a top ram bolt, washer
and nut to attach the top of the ram to the boom.
Supports
Bolt (#30)
Figure J.
Slide the boom extension into the boom and use the
bolt, washer and nut to secure at the desired load
Bolt (#30)
rating.
Use the bolt, washer and nut to attach the hook and
chain to the end of the boom extension.
OPERATING INSTRUCTIONS
Read ENTIRE IMPORTANT SAFETY INFORMATION section at beginning of this manual including
all text under
subheadings therein before set up or use of this product.
Note: once assembly is complete, tighten all bolts before initial operation.
375KG LOAD
Bleeding instructions
Important!
Before fi rst use, check for proper hydraulic oil level and thoroughly test the equipment.
If it does not work properly, bleed excess air from its hydraulic system as follows:
1. Open release valve and lower ram completely.
2. Remove oil plug and fi ll with hydraulic oil (sold separately) to full level.
3. Apply downward pressure to the boom and pump the ram handle quickly several times.
Post
Leg Leg
Support
The bends of the
Supports face out
Post
at the top and in
at the bottom as
shown above.
Bolt (#30)
Nut
Lock
Washer
Washer
Figure G
Nut
Washer
Ram
Nut
Washer
Bolt (#30)
Figure I
Figure K
Bolt (#30)
Nut
Lock Washer
Washer
Bolt
(#19)
Figure H
attach the top of the Ram to the Boom.
Nut
Washer
Boom Bolt (#16)
375KG LOAD
Figure J
Boom Bolt
Figure L
Figure G
Nut
Washer
Boom
Ram
Nut
Washer
Bolt (#30)
Figure I
Boom Extension
Nut
Lock Washer
Washer
Figure K
Chain Bolt (#13)