CLAS OH 0336NBL Mode D'emploi page 13

OH 0336NBL 1T FOLDABLE CRANE
Caster's assembly
Figures A,B and C.
To attach casters to the rear section of the base, align the four mounting holes in each caster
with the four mounting holes on the underside of each base end. Secure in place using four
corresponding caster bolts, washers, lock washers and nuts.
The bolts must match the weel size.
Rear section of the base
Nut
Lock
Base
Washer
Large
Washer
Caster
Large Caster Bolt (#27)
Figure A
Lock Washer
Base assembling
Small Caster Screw
Figures D and E.
Leg
Slide legs into front of the base and lock legs in place using the lock pins. To insert the lock
pins lift up on front of base until holes line up. After all four lock pins are inserted, insert one
Nut
Lock
R-pin through small hole at end of each lock pin until it snaps into place.
Washer
Large
Note: make sure lock pins are secure before proceeding.
Caster
Washer
Large Caster Bolt (#27)
Figure C
Base
R-Pins
Lock Pins
Figure E
Front section of the base
Base
Base
Small
Caster
Washer
(#24)
Figure B
Base
Nut
Lock
Washer
Washer
Legs
Figure D
Lock
Washer
Washer
Base
Large Caster Bolt (#27)
Washer
Lock Washer
Small Caster Screw
(#24)
Figure B
Base
Legs
Figure D
Boom Bolt (#16)
Post
Lock Pins
Base
Washers
Nut
Lock
Washer
Washer
Large Caster Bolt (#27)
Figure A
Nut
End of each legs
Base
Large
Caster
Base
Figure A
Large
Caster
Small
Caster
Washer
Lock Washer
Large Caster Bolt (#27)
Small Caster Screw
(#24)
Figure B
Leg
Nut
Washer
Large
Caster
R-Pins
Large Caster Bolt (#27)
Lock Pins
Figure C
Legs
Figure D
R-Pins
Boom Bolt (#16)
Post
Figure E
Base
Washers
Base
Large
Caster
Leg
Nut
Lock
Washer
Small
Caster
Washer
Figure C
Lock
Washer
Figure E