Precautions And Safety Measures - Amprobe AT-6000 Manuel De L'utilisateur

1. PRECAUTIONS AND SAFETY MEASURES

General
For your own safety and to avoid damage to the instrument it is suggested to follow the
procedures listed below:
NOTE: Before and during measurements be diligent to follow the instructions.
• Make sure that the electrical instrument is operating properly before use.
• Before attaching any of the conductors, make sure the voltage present in the
conductor is within the range of the instrument.
• Keep the instruments in their carrying case when not in use.
• If the Transmitter or Receiver will not be used for a long time, remove the batteries to
prevent leakage in the instruments.
• Use Amprobe approved cables and accessories only.
Safety precautions
• In many instances, dangerous levels of voltage and/or current may be present. Therefore,
it is important to avoid direct contact with any uninsulated current carrying surfaces.
Insulated gloves and protective clothing should be worn in hazardous voltage areas.
• Do not measure voltage or current in wet, damp or dusty places.
• Do not measure voltage in the presence of gas, explosive materials or combustibles.
• Do not touch the circuit under test if no measurement is being taken.
• Do not touch exposed metal parts, such as unused terminals and circuits.
• Do not use the instrument if it appears to be malfunctioning (i.e. if you notice
deformations, breaks, leakage of substances, absence of messages on the display, etc).
SYMBOLS
�
Caution! Refer to the explanation in this manual.
X
WARNING HAZARDOUS VOLTAGE. Risk of electric shock.
Consult user documentation.
T The equipment is protected by double insulation or reinforced insulation.
Earth (Ground).
Fuse.
Battery.
Certified by CSA Group to North American safety standards.
®
Conforms to relevant South Korean EMC Standards.
Electromagnetic Compatibility:
Korea (KCC): Class A Equipment (Industrial Broadcasting & Communication Equipment)
This product meets requirements for industrial (Class A) electromagnetic wave
[1]
equipment and the seller or user should take notice of it. This equipment is intended for
use in business environments and is not to be used in homes.
Conforms to relevant Australian standards.
Complies with European Directives.
This product complies with the WEEE Directive marking requirements. The affixed
label indicates that you must not discard this electrical/electronic product in domestic
household waste. Product Category: With reference to the equipment types in the
WEEE Directive Annex I, this product is classed as category 9 "Monitoring and Control
Instrumentation" product. Do not dispose of this product as unsorted municipal waste.
2
[1]