Fast Preheating; Setting Cooking Time - Whirlpool AKZ 339 Manuel D'utilisation Et D'entretien

FAST PREHEATING

1. Turn the "Functions" knob to the symbol
2. Confirm by pressing
3. If the proposed temperature is that desired, press button
described in previous paragraphs. The message PRE appears on the display. When the set
temperature is reached, the corresponding value (e.g. 200°) and an acoustic signal will sound. At the
end of preheating, the oven automatically selects the conventional function
At this point food can be placed in the oven for cooking.
4. If you wish to set a different cooking function, turn the "Functions" knob and select the desired
function.

SETTING COOKING TIME

This function can be used to cook food for a set length of time, from a minimum of 1 minute to the
maximum time allowed by the selected function, after which the oven switches off automatically.
1. Once the temperature is confirmed, the symbol
2. Turn the adjustment knob to display the desired cooking time.
3. To confirm the cooking time, press button
The oven automatically confirms your selection 10 seconds after the last operation.
SETTING END OF COOKING TIME/START DELAYED
IMPORTANT: the start delayed setting is not available for the following functions: FAST
PREHEATING, BREAD/PIZZA, CONVECTION BAKE.
N.B.: with this setting, the selected temperature is reached in a more gradual way, so cooking times
will be slightly longer than stated in the cooking table.
The end of cooking time can be set, delaying the start of cooking by up to a maximum of 23 hours and
59 minutes. This can only be done once cooking time has been set.
After setting cooking time, the display shows the end of cooking time (for example 15:45) and the
symbol flashes.
To delay the end of cooking time, and thus also the cooking start time, proceed as follows:
1. Turn the "Browse" knob to display the time you wish cooking to end (for example 16:00).
2. Confirm the selected value by pressing button
indicating that the setting has been made correctly.
3. The oven will automatically delay the start of cooking so as to finish cooking at the set time.
INDICATION OF THE RESIDUAL HEAT INSIDE THE OVEN
If at the end of cooking, or when the oven is switched off, the temperature inside the oven is over 50°C, the
display shows the word HOT and the current temperature. When the residual heat reaches 50°C, the display
shows the current time again.
: the settings are shown on the display.
3
3
to select the fast preheating function.
. To change the temperature, proceed as
3
flashes.
.
: the two dots of end of cooking time flash,
3
GB11
.