Installation; Maintenance - Carbest 48014 Manuel D'utilisation

EN
EN

Installation

The system is prepared as a plug'n'play system so that the plug of the receiver is
connected directly to the wiring harness of the VanHeat heater.
The power supply is provided via this connector. A separate power supply is not
necessary. This means that no separate cables need to be laid and connected.
The hand-held transmitter is delivered in ready-to-use condition with the
CR2477 lithium-ion battery inserted.

Maintenance

The battery life depends on the use of the hand-held transmitter. If the range
decreases considerably or it is no longer possible to carry out any functions, the
battery must be replaced. If the control LED does NOT light up, this also indicates
a weak or empty battery.
To change the battery, open the battery compartment on the back (e.g. with a
coin) by turning the battery compartment cover anti-clockwise to the left in the
direction of the arrow "OPEN" by about 90°. Remove the old battery and insert a
new CR2477 lithium-ion battery into the battery compartment according to the
polarity markings (+ upwards).
Close the battery compartment by placing and pushing in the battery
compartment cover (triangle on triangle) and turn it to the right until it stops.
Remove the battery from the handheld transmitter if it will not be used for a
long time.
The product is otherwise maintenance-free for you. Leave any repair work to a
specialist.
Clean the product with a soft, clean, dry and lint-free cloth. Do not use any
cleaning agents containing solvents, as this may attack the plastic housing and
the labelling.
Troubleshooting
During use, the remote control may not operate normally. In this case:
Shorten the distance between transmitter and receiver
CARBEST Wireless remote control for VanHeat diesel parking heaters | 48014
14
30