Functions Indication Table; Function Description - IDEAL 61-327 Manuel D'utilisation Et De Sécurité

Functions Indication Table

Function Description
LCD One LCD. Displays a "-" symbol for all negative readings, displays "AC" for
alternating current or "DC" for direct current.
LCD White backlight. The backlight will automatically power off after 5 minutes
Backlight of inactivated
High 1) Only applicable to ACV / DCV
Voltage 2) For ACV and DCV, when voltages in excess of 30V is measured or the
Alarm measured voltage is over limit, then the high voltage alarm symbol "
appears on the screen display, simultaneously the LED remains RED and
beeping lasts for 1 second then becomes silent during measurement.
Regular 1) When turning the dial switch to any setting position except OFF, the buzzer
Prompt will beep one time and the NCV LED flashes one time.
2) When the button selection is valid, the buzzer will beep one time; When the
button is invalid, the buzzer will beep twice.
3) About 1 minute before the automatic shutdown, the buzzer will beep 5
times continuously, and 1 long beep before the unit shuts down.
4) When the automatic shutdown function is canceled, the buzzer will beep 5
times when it reaches the APO time setting.
Over Range LCD displays "OL" when over range is encountered.
Indication
Low Battery When the battery voltage < 3.6 ±0.2V, the low battery indication '
Indication displayed on the screen and the meter will still work normally. When the
battery voltage drops to less than 3.1 ±0.2V, "bAtt" is displayed for 5 seconds
then shuts off. When the battery voltage is less than 2.3V, accuracy is no
longer assured.
APO The unit will be automatically power off after 30 minutes of inactivity and
enter the low-power state. Current draw is approx. ≤50 micro A.
Restore All the buttons can wake up the unit, rotate the dial switch to any setting
APO except OFF to wake it up.
Disable Pressing the "HOLD" key while turning on the unit on at the same time, will
Auto Power cancel the auto shutdown function. Buzzer will beep 5 times and the LCD will
Off Function not display the "APO" symbol.
Mechanical Single Injection Molding with rubber boot.
Housing
."
' is
18