Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION OF THE CONTROL PANEL
r
A: ON/OFF button
B: MODE selection button
C: FAN speed selection button
D: Programmed operation increase temperatura
E: Programmed operation de crease temperatura
F: COOL mode light
G: DEHUMIDIFYING mode light
H: FAN mode light
1 : Display a rea
J: Auto-speed fan mode light
K: Low-speed fan mode light
L: Mid-speed fan mode light
M: High-speed fan mode light
N: HE AT mode light
(Heatingmodelonly)*
"*" means only the heat pump model have this function.
OPERATING FROM THE CONTROL PANEL
The control panel enables you to manage ali the main functions
of the appliance, but to fully exploit its potential, you must use the
remate control unit.
TURNING THE APPLIANCE ON
•
Plug into the mains socket.
Two lines appear on the display indicating that the appliance
is in standby.
•
Press the c.!) button until the appliance comes on. The last
function active when it was turned off will appear .
.,/
Never turn the air conditioner off by unplugging from the mains. Always press the
button(!), then wait for a few minutes before unplugging. This allows the appliance
to perform a cycle of checks to verify operation.
F
G H
N
J
K L
*
* •
-:+:-
"C/"F
B
E
A
D
58
M
'
e
B
ºC/ ºF
Publicité
Table des Matières
