Preparing For Use - Haverland TAC-0918 Mode D'emploi

PREPARING FOR USE

The instructions below will enable you to prepare your air condi­
tioner for operation as efficiently as possible.
Befare use, make sure the air intake and outlet grilles are unob­
structed.
AIR-CONDITIONING WITHOUT INSTALLATION
Just a few simple steps and your comfort is ensured with your
appliance:
• Fit the air exhaust hose in the housing at the back of the
appliance (fig.A).
•
Fit the window outlet to the end of the hose.
•
Place the air conditioner near a window or French window.
Adjust the length of the hose to reach the window.
•
Make sure the air exhaust hose is unobstructed.
• Open the window or French window slightly and position the
outlet (fig.B).
•
lf you have a sash window, place the bracket on the window
sill, extend the bracket fully within the window frame fix the
bracket by using the pin, then lower the window onto the
bracket. lnsert the window outlet of the exhaust hose into the
Slot, then connect the hose to the air conditioner (fig.C).
•
lf you have a double window, use the sucker provided to hold
the two parts of the window together (fig. D).
Keep the air hose as short and free of curves as possible to
avoid bottlenecks .
.,/ When installing the air conditioner semi-permanently, you
should leave a door slightly open (as little as 1 cm) to gua­
rantee correct ventilation.
57