Unpacking & Assembly - Powerplay PJR1500 Manuel D'instructions

U & a
nPacking
After unpacking the POWERPLAY
•
Familiarize yourself with the parts in the package by comparing them to those listed on the
"PACKAGE CONTENTS" page.
• The POWERPLAY
screwdriver to install the handle to the main unit.
NOTE: Some parts may or may not be already assembled.
• Install the handle to the POWERPLAY
holes provided on the POWERPLAY
not use a power screwdriver. When the screw is completely tight, give a small final clockwise twist
of the screwdriver. Do not over tighten.
• Slide the spray gun holder onto the left side of the washer when facing it. This does not require
any screws. (Fig. 2)
• Slide cord hook holder onto the right side of the washer when facing it. This does not require any
screws. (Fig. 3)
en 8
SSembLy
POWER WASHER, lay out parts and accessories.
TM
y POWER WASHER requires some minor assembly. You'll need a Phillips
TM
TM
TM
OFF/O
ON/I
POWER WASHER (Fig. 1). Place the screws in the
POWER WASHER and handle, screw them together. Do
Fig. 2
Fig. 1
OFF/O
ON/I
Fig. 3