How To Clean - Powerplay PJR1500 Manuel D'instructions

• Release the safety lock button on the spray gun by pressing the safety lock button from right to
left (Fig. 20). While pointing the spray gun in a safe direction, squeeze the trigger on the spray
gun until there is a steady stream of water, letting the water and air out of the hose.
• Turn the power switch to the 'ON' (|) position. The unit will turn on for 1 - 2 seconds and shut off,
this is a normal function of the (TSS) auto start feature. Squeeze the spray gun trigger to begin
pressure washing.
• Squeezing rapidly will cause the (TSS) feature to miss an on/off cycle that may prevent from
turning on while squeezing trigger after rapid squeezing. Use slow deliberate trigger pulls to
avoid such symptoms.
H t c
oW o Lean
Cleaning nozzles
• A clogged or partially clogged nozzle can cause significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while spraying.
• Turn off the unit
• Turn off the water supply to the unit
• Relieve any pressure trapped in the hose by squeezing the trigger 2-3 times, and then lock the
spray gun by pushing the lock button from left to right.
• The screen inside the clear adapter should be cleaned periodically. Insert a pen or pencil in small
hole at the end of the adapter. The screen filter will slide out (Fig. 21). Rinse it with clean water,
and then place it back in the adapter.
en 14
Unlock
Lock
Fig. 21
Fig. 20