Toyotomi zibro LC-150 Manuel D'utilisation page 18

B
FILLING FUEL
Fill the removable tank in a suitable place since there can always be some
spillage. Follow the procedure below:
1 Make sure that the heater is switched off.
2 Open the upper lid and lift the removable tank out of the heater (Fig. B).
Put down the removable tank (cap pointing upwards, handle on floor) and
screw off the fuel cap (Fig. C).
NOTE: Some drops may leak from the tank.
3 Fill the removable tank using a fuel pump (refer to fuel pump operation
instructions.) Make sure that it is in a higher position than the removable tank
(Fig. D). Insert the ribbed hose into the opening of the removable tank.
4 Check the removable tank fuel gauge while filling the tank (Fig. E). Stop
filling once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
5 Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
6 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
SETTING THE CLOCK
It is only possible to set the correct time and day, when the heater is connected to
the mains and not burning. Use the adjustment keys
sion/day/set (weekly timer)
First press one of the three keys to switch on the function (the 4-digit ¸ will start
blinking). Next, set the hours using the key (
key ( min.) and the day using the key extension/day/set
Press once to increase the value by one step. When you hold down the key, the
value will continue going up, until you release the key again. After approximately
10 seconds the 4-digit will stop blinking and the setting will be locked (Fig.F). 5
minutes after switching off the heater, the information on the display will disap-
pear and the heater will automatically switch into the stand-by position.
!
When the heater has been unplugged for more than 30 minutes (or after a
power failure), the time and the day need to be set again.
D
WEEKLY TIMER
Here is an example on how the weekly timer can be programmed:
Monday
P1 ON 6:30
P1 OFF 8:45
P2 ON 12:00
P2 OFF 14:00
P3 ON 18:00
P3 OFF 23:00
4
6
to set the day.
Tuesday Wednesday Thursday
6:30 6:30 6:30
8:45 8:45 8:45
15:00 18:00 12:00
23:00 23:00 14:00
18:00
23:00
to set the time and exten-
hour) and the minutes using the
.
Friday Saturday Sunday
6:30 10:00
8:45 23:00
12:00
14:00
18:00
23:00
empty
F: When the 4-digit
stops blinking, the set-
ting has been locked to
the indicated value.
9:00
23:00
C
D
E
full