Expert Mode - Sun Microsystems GDM-5510 Mode D'emploi

x EXPERT mode
You can make additional adjustments to the color in greater detail
by selecting the EXPERT mode.
1
Press the MENU button.
The menu appears on the screen.
2
Move the control button up or down to highlight
COLOR and press the control button.
COLOR
R
G
B
R
G
B
3
Move the control button up or down to adjust the
R (red), G (green), and B (blue) component of input
signal for each of GAIN (6) and BIAS (
press the control button.
If you want to reset the EXPERT adjustments, select
0 (RESET) in COLOR menu. Then select OK in the RESET
window.
x sRGB mode
The sRGB color setting is an industry standard color space
protocol designed to correlate the displayed and printed colors of
sRGB compliant computer products. To adjust the colors to the
sRGB profile, simply select the sRGB mode in the COLOR
MODE ( ) menu of the OPTION (
However, in order to display the sRGB colors correctly (γ = 2.2,
6500K), you must set your computer to the sRGB profile. If you
select this mode, you cannot operate the CONTRAST/BRIGHT
menu adjustments.
COLOR
s RGB
Note
Your computer and other connected products (such as a printer), must be
sRGB compliant.
: EXPERT
45
X I T :
E MENU
). Then
) menu.
: s RGB
: /
X I T :
E
MENU
Restoring the color from the EASY, PRESET, or
sRGB modes (IMAGE RESTORATION)
The colors of most display monitors tend to gradually lose
brilliance over several years of service. The IMAGE
RESTORATION feature found in the EASY, PRESET, and
sRGB menus allows you to restore the color to the original factory
quality levels. The explanation below explains how to restore the
monitor's color from the EASY mode for example.
First, select the EASY, PRESET, or sRGB mode in the OPTION
menu (page 12).
1
Press the MENU button.
The menu appears on the screen.
2
Move the control button up or down to highlight
COLOR and press the control button.
The COLOR menu appears on the screen.
3
Move the control button up or down to highlight
IMAGE RESTORATION. Then press the control
button.
4
Move the control button up or down to select OK.
Then press the control button.
COLOR
The picture disappears while the color is being restored (about
2 seconds). After the color is restored, the picture reappears
on the screen again.
Notes
• Before using this feature, the monitor must be in normal operation
mode (green power indicator on) for at least 30 minutes. If the monitor
goes into power saving mode, you must return the monitor to normal
operation mode and wait for 30 minutes for the monitor to be ready.
You may need to adjust your computer's power saving settings to keep
the monitor in normal operation mode for the full 30 minutes. If the
monitor is not ready, the following message will appear.
COLOR
• The monitor may gradually lose its ability to perform this function due
to the natural aging of the picture tube.
13
I MAGE
RESTORAT I ON
OK
CANCEL
X I T :
E MENU
I MAGE
RESTORAT I ON
AVA I LABLE
AFTER
WARM UP
X I T :
E
MENU
EN